From: Lawrence.London@bbs.oit.unc.edu (Lawrence London) Subject: Re: Other compost questions Date: Fri, 5 Jun 1992 16:00:18 GMT Putting the compost pile on a semi-level plateau on a shady hillside is good. Rainfall can sluice through it to keep it moist but well-drained; garden at bottom of hill will get nicely enriched with compost tea. To start the pile mix 25% animal manure (any material high in nitrogen will work fine, food garbage, blood meal, fish emulsion, etc.) with 75% biomass (weeds, grasses, grains, hay, leaves, sawdust, bark, spoiled silage, etc.) the proportions vary according to the materials used: sawdust, bark and leaves will require you to mix a greater quantity of nitrogenous material with it for it to work off; the increased amount is in the range of 10-20%. Actually most weeds and grasses require no additional N to work off. There's an art to composting, esp. when you are using manure alone. The idea is to get it to decompose completely with minimum loss of N. The BioDynamic people seem to have this process down. Sir Albert Howard ("An Agricultural Testament") describes the "Indore" composting method, developed in India many years ago. You can add bio- activators (compost starters) to innoculate the pile with the various bacteria that do the work of breaking down the organic matter. They require nitrogen, oxygen and water to maintain an effective population. If the pile gets too wet for too long the aerobic bacteria will die off and be replaced by anerobic ones; the pile will then become putrid, breed sawflies and lose much nitrogen. Anerobic decomposition is used on some farms where large quantities of manure with high water content are to be processed. The manure is put into pits and sometimes lagoons where it breaks down prior to being pumped into spray rigs for field application. Nitrogen loss is kept to a minimum and the resulting fertilizer is usable as plant food shortly after application. Mix the ingredients and form the pile into a rectangle with the height about 1/4 to 1/3 the width; length isn't important except where shade and drainage are concerned. Never add any rock powders to the pile, especially lime. Save those for application to the garden beds in Fall. Lime can slow or stop the decomposition process. Aerobic bacteria (thermophilic bacteria, _azotobacter_ I think) will cause Ph swings in the pile as it begins to heat with subsequent levelling off after the last temperature rise. After the first heat has finished turn the pile and let it go again again. Do this as often as necessary then let the pile rest until all material in it is completely broken down. Be sure to keep it moist during dry weather. [corrections and additions to the above will be appreciated :-) In the Fall I dig into my beds combinations of the following: To raise Ph: high calcium limestone - either hi-cal lime or ground shell meal dolomitic agricultural limestone, unburnt To lower Ph: powdered sulphur rock or colloidal phosphate pyrophyllite screenings basalt screenings (any rock dusts from nearest rock quarry) granite screenings (or Hybro-Tite fertilizer, a hi-potash hybrid granite powder from Lithonia, Georgia) New Jersey Greensand All of these supply macronutrients and trace minerals. The May/June issue of "Organic Gardening" magazine has an interesting article on the use of rock dusts as soil amendments. Descriptions of various types and combinations of rock are given with lists of commercial sources. Any screenings you can get from a rock quarry will work wonders in any garden. Some (like pyrophyllite dust), when mixed with organic matter will produce a seed starting and potting medium of unbelievable quality. The Pyr. dust is a fine aggregate with traces of talc, some potash and trace minerals. It never crusts over or gets stiff like mortar sand (unwashed), will hold moisture for long periods of time yet provide more than adequate drainage and promote growth of long, very dense root systems. I have never found a mix that works as well as this stuff.